Introduction

• All safety instructions described below are intended to protect the user and other individuals from physical harm and household damage.
• Safety instructions are classified and described according to the level of harm and damage caused by improper use, as shown below.

Description of Symbols

To Page Top

Precautions for Use

Warning

• Keep out of reach of children. Do not let children play with the product.
  There is a risk of burns or injuries.

  

Caution

• Do not disassemble or attempt to repair the product by yourself.
  There is a risk of failure or accident. The contents may leak.
  Do not use the product for any purpose other than keeping beverages warm or cold for drinking.
  There is a risk of accidentally drinking the contents and of damaging the product.

• Do not use the product if you can hear the sound of water from inside the vacuum double-layer structure (vacuum layer) of the body.
  If water in the vacuum layer seeps out, it may cause health problems if ingested. It will also reduce the thermal insulation performance and there is a risk of burns if a hot beverage is poured into the product.

  

• Check that the lid gasket and stopper gasket are attached and that there is no leakage of the beverage before using the product.
  There is a risk that the contents may leak, causing burns or stains.
• Install only the parts intended for use with the product.
  If any other parts are installed, there is a risk that the contents may leak, causing burns or stains.
• Do not use the product if its ability to retain heat declines.
  Hot beverages can make the product very hot, potentially causing burns.
• Do not place the product near stoves, open flames, or other sources of extreme heat.
  There is a risk of burns or deformation or discoloring of the product.
• Do not heat the product in a microwave oven.
  There is a risk of injury or failure due to sparks.
• Do not put the product in a freezer.
  Contents may leak or the product may be damaged.
• Do not knock over, drop or expose the product to excessive shocks.
  There is a risk of damage to the product, a reduction of its heat- or cold-retention ability, rusting, paint /printing /plating peeling*, or leakage of contents.
  ＊Limited to products with processing such as painting, pringing and plating.
• Do not remove the caution sticker on the product.
  If it is removed, there is a risk of diminished heat (cold) retention performance.
• Do not scratch or rub the surface of the body, resin parts, or seals with nails or hard objects.
  Causes of damage and peeling.
• Do not use the product in a moving vehicle.
  This may result in burns or soiling of clothes or of the interior of the vehicle. Using the product while you are driving is very dangerous, as you may be distracted

To Page Top

Precautions when Adding Beverages

Caution

• Do not touch the brim of the product with a kettle spout.
  The product may fall over, causing burns or injuries to the skin, or a scratch or deformation to the product.
  (G) Brim

  

• Do not pour the beverage into the bottle while the spout is set.
  The contents may leak or the product may fall over, causing burns or injuries to the skin. The product may also be scratched or deformed.
  (E) Spout

  

• Be sure to fill the product with drink below the maximum level shown in the diagram.
  If the contents exceed the specified line, they may leak or overflow, potentially causing burns.

  

• Do not put dry ice or carbonated beverages in the product.
  The air pressure inside the product may increase, causing the stopper and lid to become stuck or prone to shattering, or the parts to be damaged.
• Do not store milk, dairy products, or certain fruit juices in the product.
  The contents may decay or spoil. Long-time spoilage can create gases that raise the air pressure inside the product due to decay or spoil, causing the stopper and lid to become stuck or prone to shattering, or the parts to be damaged, and result in scattering of fragments.
• Do not store soups or beverages containing salt in the product.
  The product may become decayed, spoiled, or rusted.
• Do not store tea leaves or peeled fruit.
  They may clog the spout, resulting in leakage of the contents.
• Be sure to set the stopper in proper position.
  Contents may leak and cause soiling or skin burns.

To Page Top

Precautions when Carrying the Product

Caution

• Do not place the product in a bag if its exterior is wet.
  There is a risk of rust, odor, or soiling.
• Do not leave the product in a bag for a long time.
  The storage conditions may change and there is a risk of rust or odors.
• Do not swing the product while holding the handle on the lid.
  Causes of injury and/or damage if the product hits people or other materials.
• When carrying by the lid handle, use caution not to turn or produce any　other action that may cause the lid to loosen.
  Doing so may cause the main unit to fall off due to the loosen stopper.
• Before using the can holder, check its intensity.
  If the holder is not strong enough, it may come off and get damaged. This may result in bums or soiling of clothes or of the interior of the vehicle.
• When using a commercially available can holder, use the stationary type.
  If the suspension holder that is attached to the window or air conditioning outlet is used, it may come off. This may result in burns or soiling of clothes or of the interior of the vehicle.

To Page Top

Precautions when Drinking

Caution

• Do not open the lid if the product is tilted or placed near your face when it contains a hot beverage.
  This may cause the internal air pressure of the product to increase and the contents to burst out and scatter, potentially causing burns.
• Drink slowly and do not tilt the product abruptly when the product contains a hot beverage.
  Do not tilt the product abruptly. This may cause the contents to burst out, potentially causing burns.
• Drink all of the beverage as soon as possible.
  If a beverage is left inside for a prolonged period, gas may be produced by decomposition, increasing the pressure inside the body. This may prevent the stopper from opening or cause the contents to spray out.
  There is also the danger that it may damage the stopper and cause it or pieces of it to fly off.

To Page Top

Precautions when Cleaning

Caution

• Be sure to clean the product immediately after use, especially after consuming sports drinks.
  Rinse the inside of the product well, even if you are going out, for example, and don't have time to wash it thoroughly.
  Mold, rust, or holes may appear.
• Do not use chlorine-based bleaches.
  Causes of rust, paint/printing/plating peeling＊, and holes.
  ＊Limited to products with processing such as painting, printing and plating.
  Go here to purchase consumable parts.

To Page Top