Before the first use

You may notice an unusual odor coming from the material of the product. In this case, clean the product by following the steps below.

To Page Top

How to use

1. Turn the stopper to remove it.

   Check that the lid gasket, and stopper gasket are attached to the stopper.
   (A) Stopper (H) Body

   

2. To keep your beverage warm/cool longer, first pour a small amount of hot/cold water into the main body and let it sit for one or two minutes.

   Discard the hot/cold water after preheating/precooling.

3. Pour your hot/cold beverage into the main body.

   • Pour appropriate amount of beverages.
   • Do not insert large cubes of ice. Use small cubes or crushed ice.

   (G) Brim (H) Body

   

   

   

4. Place the main body in an upright position and turn the stopper to close it.

   • Turn the stopper as far as it will go to securely close it.
   • Check that the lid and spout are securely closed.

   (C) Lid (E) Spout

   

5. Hold the main body and spout, and turn the lid, and then drink the beverage.

   

   Caution

   • Do not tilt the body immediately after pouring in a hot beverage and closing the lid. The contents may leak.

   (C) Lid (E) Spout (H) Body

   

6. After drinking the beverage, keep the product in an upright position and securely close the lid.

   Securely tighten the lid until it does not turn any farther.
   (C) Lid (E) Spout

   

Caution

• Make sure the handle on the lid does not suffer any strong impact while carrying it. The lid may open.
• When carrying by the lid handle, use caution not to turn or produce any other action that may cause the lid to loosen.
• Do not use the bottle by hanging it with any metal fittings or strings attached to the handle on the lid. Doing so may cause the main unit to fall off due to the loosen stopper.
• If you place the product in a bag, make sure the handle on the lid
  keeps away from bag contents. The lid may open.
• If you place the product in a bag, make sure it is upright to
  prevent any accidental leakage.
  The product may leak if you place it on its side.

To Page Top