instruction manual
- Vacuum Insulated Bottle [MCZ-S]
- How to Clean
INDEXProduct top/Specifications
How to Clean
- Clean the product on the same day after every use.
- Use mild kitchen detergent (for table or cookware).
- Use a soft sponge or cloth.
- Clean the product thoroughly to prevent any odor.
Parts to wash after each use
- Wash each part using a sponge with diluted detergent water or lukewarm water, and then thoroughly rinse it with water.
- Wipe the water off with a dry cloth and dry the parts thoroughly.
- (C) Lid
- (D)＊ Lid gasket
- (E) Spout
- (F)＊ Stopper gasket
- (H) Body
- ＊ Remove and wash.
Caution
- Do not soak the body and lid when washing them. Water may enter.
- After washing the whole body, immediately use a dry cloth to wipe off the moisture on its outer surface. Not wiping off all droplets could leave water stains or cause rust and other marks.
- Do not use thinners, cleansers, bleaches, cleaning wipes, metallic scrubbing brushes, or nylon scrubbing brushes.
- Do not use a dishwasher or dish dryer, and do not wash with boiling water. (Except gasket)
- Be sure to attach the gaskets.
- Dry the body and lid completely after removing stains when not in use for a long time.
If marks start to become visible
on the inside of the main body
For red, rust-like spots or rough areas
Such staining can be caused by minerals in water, such as calcium, magnesium, and iron. It is recommended to clean them with citric acid, which is available at supermarkets and drug stores.
- Dilute the citric acid (approximately 10g) in lukewarm water, and then pour it into the main body.
- After a few hours have elapsed, wash the main body with a soft brush and then thoroughly rinse it.
- Dry the main body completely.
If an odor remains on the gasket
Depending on the contents, the odor may remain on the gasket. In this case, leave the gasket in boiling water for approximately 30 minutes to reduce the odor. If the odor is still noticeable, purchase a new gasket（sold as an optional part）.
Go here to purchase consumable parts.
Attaching and Removing the lid gasket
To remove
Slowly remove the lid gasket while holding and turning it.
(D) Lid gasket
To attach
When attaching the lid gasket, make sure to fit it completely in the proper direction.
Caution
- Do not attach the gasket in the incorrect place or direction. The contents may leak.
(D) Lid gasket
Attaching and removing the stopper gasket
To remove
Slowly remove the stopper gasket while holding its edge.
(F) Stopper gasket
To attach
When attaching the stopper gasket, make sure to fit it completely in the proper direction.
Caution
- Do not attach the gasket in the incorrect place or direction. The contents may leak.
(F) Stopper gasket
