Before the first use

You may notice a particular odor coming from the material of the product. In this case, clean the product with the following step.

To Page Top

How to Use

1. Turn the stopper to remove it.

   • Remove the lid and spout cover.
   • Check that the gasket is attached to the stopper.

   

2. To improve the thermal retention performance, pour a small amount of hot/cold water into the main body beforehand and let it sit for 1 or 2 minutes.

   Discard the hot/cold water after preheating/precooling.

3. Pour your hot/cold beverage into the main body.

   • To avoid adding too much beverage, add it up to the position shown in the figure (slightly less than full).
   • Do not put large cubes of ice. Use small cubes or crushed ice.

   

   (I) Brim
   (J) Main body

4. Place the main body in an upright position and turn the stopper to close it.

   • Check that the spout is securely attached to the spout cover.
   • Turn the lid and spout cover as far as it will go to securely close.

   

5. To drink, hold the main body and the spout cover, and turn the lid.

   Caution

   • Do not turn the spout cover and the lid at the same time. Otherwise, the contents may leak.

   

6. After drinking, return the product to an upright position and securely close the lid.

   Securely tighten the lid until it does not turn any farther.

   

Caution

• When attaching the stopper to the main body, turn the spout as far as it will go to securely attach.
• When putting the product into a bag, place it standing up to prevent any possible leakage. Otherwise, the contents may leak.

To Page Top