Wash each part using a sponge and diluted detergent water or lukewarm water, then thoroughly rinse it with water.
Wipe any droplets off with a dry cloth and dry the parts thoroughly.
(A) Stopper
(B) Lid
(C) Lid gasket*
(D) Spout cover
(E) Upper spout gasket*
(F) Spout
(H) Lower spout gasket*
(J) Main body
* Remove and wash.
Caution
Do not soak the main body or stopper for a long time when there is a risk that water may get into the parts.
After washing the main body, immediately use a dry cloth to wipe off the droplets. If all droplets are not wiped off, they may leave water stains, cause rust, or stain other items.
Do not use paint thinner, cleansers, bleach, cleaning wipes, metal scrubbing brushes, or nylon scrubbing brushes.
Do not use a dishwasher or dish dryer, or wash with boiling water. Do not use boiling water. (Not including gaskets.)
Be sure to attach the stopper and gaskets.
If the product will not be used for a long time, fully clean and dry it.
When red, rust-like spots or a substance that is rough to the touch appears
Such stains can be caused by minerals in water, such as calcium, magnesium, and iron. When cleaning these substances, please use citric acid, which is available at supermarkets and drug stores.
Dilute the citric acid (approximately 10 g) with lukewarm water, then pour it into the main body.
After 2 to 3 hours, wash the main body with a soft brush and then thoroughly rinse it.
Fully dry the main body.
When an odor remains on the gasket
Depending on the beverage, the beverage odor may remain on the gasket. In this case, leave the gasket in boiling water for approximately 30 minutes. If the odor is still remains, please purchase a new gasket (sold separately). Click here to purchase consumable parts.