Check that the lid gasket and stopper gasket are attached to the stopper.
(A) Stopper
To improve the thermal retention performance, pour a small amount of hot/cold water into the body beforehand and let it sit for 1 or 2 minutes.
Discard the hot/cold water after preheating/precooling.
Pour your hot/cold beverage into the body.
To avoid adding too much beverage, add it up to the position shown in the figure (slightly less than full).
Do not put large cubes of ice. Use small cubes or crushed ice.
Putting in ice causes the pressure inside the body to decrease, which can cause the gasket to come off when opening the stopper. If this occurs, reattach the gasket in its original position.
Be sure to wipe off any spillage on the outside of the body.
Due to the structure of the product, if a cold beverage is poured in when the humidity is high, condensation may occur and water droplets may form on the stopper.
Place the product in an upright position and turn the stopper to close it.
Turn the stopper as far as it will go to securely close it, and check that the stopper is securely closed.
Set the safety lock to “Lock”. Close it securely so that the safety lock is locked in place with a “click”.
Set the safety lock to “Release”, press the button, open the lid, and drink.
Do not tilt the product immediately after pouring in a hot beverage and closing the lid. Otherwise, the contents may leak.
(C) Lid (F) Button
After drinking, return the product to an upright position and securely close the lid, and lift the button to “lock” the safety lock.
Close it securely so that the safety lock is locked in place with a “click”.
(C) Lid (F) Button
Caution
When carrying the product, do not expose the product to excessive impacts. Even if the safety lock is set to “Lock”, the lid may open with an excessive impact.
When carrying by the lid loop, be careful not to turn the product in a direction that may cause the stopper to loosen or to subject the product to strong vibration or impact. Make sure that the stopper does not become loose. The body may fall off if the stopper is loosened.
Do not use the bottle by hanging it with any metal fittings or strings attached to the loop on the lid. There is a risk of loosening the stopper and dropping the body.
Do not keep the body sideways. It may cause the contents to leak.
When putting the product into a bag, place it standing up to prevent any possible leakage. Otherwise, the contents may leak.
