Before the first use
You may notice a particular odor coming from the material of the product. In this case, clean the product with the following step.
- Check that all the gaskets are attached.
- Pour hot water into the main body and securely close the lid.
-
Hold the main body and gently shake it several times to rinse the inside thoroughly.
Caution
- Do not shake it excessively. Doing so may cause hot water to spray out, resulting in burns.
- Discard the hot water and clean each part.
Click here to see cleaning instructions.
To Page Top
How to Use
-
Turn the stopper to remove it.
- Remove the lid and spout cover.
- Check that the gasket is attached to the stopper.
-
To improve the thermal retention performance, pour a small amount of hot/cold water into the main body beforehand and let it sit for 1 or 2 minutes.
Discard the hot/cold water after preheating/precooling.
-
Pour your hot/cold beverage into the main body.
- To avoid adding too much beverage, add it up to the position shown in the figure (slightly less than full).
- Do not put large cubes of ice. Use small cubes or crushed ice.
(I) Brim(J) Main body
-
Place the main body in an upright position and turn the stopper to close it.
- Check that the spout is securely attached to the spout cover.
- Turn the lid and spout cover as far as it will go to securely close.
-
To drink, hold the main body and the spout cover, and turn the lid.
Caution
- Do not turn the spout cover and the lid at the same time. Otherwise, the contents may leak.
-
After drinking, return the product to an upright position and securely close the lid.
Securely tighten the lid until it does not turn any farther.
Caution
- When attaching the stopper to the main body, turn the spout as far as it will go to securely attach.
- When putting the product into a bag, place it standing up to prevent any possible leakage. Otherwise, the contents may leak.
To Page Top
TIGER FOREST uses cookies to realize and improve its functions.