Introduction

• All safety instructions described below are intended to protect the user and other individuals from physical harm and property damage.
• Safety instructions are classified and described as shown below according to the level of harm or damage resulting from improper use.

Description of Symbols

To Page Top

Precautions for Use

Warning

• Keep out of reach of children. Do not let children play with the product.
  There is a risk of injuries.

  

Caution

• Do not disassemble or attempt to repair the product by yourself.
  There is a risk of failure or accident.
  Do not use the product for any purpose other than keeping beverages cold for drinking.
  There is a risk of accidentally drinking the contents, suffering burns, or damaging the product.

• Do not use the product if you can hear the sound of water from inside the vacuum double-layer structure (vacuum layer) of the body.
  If water in the vacuum layer seeps out, it may cause health problems if ingested.

  

• Check that the lid gasket and stopper gasket are attached and that there is no leakage of the beverage before using the product.
  There is a risk that the contents may leak, causing stains.
• Install only the parts intended for use with the product.
  If any other parts are installed, there is a risk that the contents may leak, causing stains.
• Do not place the product near stoves, open flames, or other sources of extreme heat.
  There is a risk of burns or deformation or discoloring of the product.
• Do not heat the product in a microwave oven.
  There is a risk of injury or failure due to sparks.
• Do not put the product in a freezer.
  Contents may leak or the product may be damaged.
• Do not knock over, drop or expose the product to excessive shocks.
  There is a risk of damage to the product, a reduction of its cold-retention ability, rusting, paint /printing / plating peeling*, or leakage of contents.
  *Limited to products with processing such as painting, printing and plating.
• Do not remove the caution sticker on the product.
  If it is removed, there is a risk of diminished cold retention performance.
• Do not scratch or rub the surface of the body, resin parts, or seals with nails or hard objects.
  Causes of damage and peeling.
• Do not open or close the lid while the stopper or lid is tilted.
  Doing so may cause drinks to leak or overflow and result in staining of clothes.
• Do not place the product on its side.
  The contents may spill out.
• Do not use the product in a moving vehicle.
  This may result in soiling of clothes or of the interior of the vehicle. Using the product while you are driving is very dangerous, as you may be distracted.

To Page Top

Precautions when Adding Beverages

Caution

• Do not touch the brim of the product with a kettle spout.
  The product may fall over, causing injuries to the skin, or a scratch or deformation to the product.

  

• Do not pour the beverage into the bottle while the stopper is set.
  The contents may leak or the product may fall over, causing injuries to the skin. The product may also be scratched or deformed.

  

• Do not pour hot liquids into the product.
  Burns may result.

• Be sure to fill the product with drink below the maximum level shown in the diagram.
  If the contents exceed the specified line, they may leak or overflow.

  

• Do not put dry ice or carbonated beverages in the product.
  The air pressure inside the product may increase, causing the stopper to become stuck or prone to shattering, or the parts to be damaged.
• Do not store milk, dairy products, or certain fruit juices in the product.
  The contents may decay or spoil. Long-time spoilage can create gases that raise the air pressure inside the product due to decay or spoil, causing the stopper to become stuck or prone to shattering, or the parts to be damaged, and result in scattering of fragments.
• Do not store soups or beverages containing salt in the product.
  The product may become decayed, spoiled, or rusted.
• Do not store tea leaves or peeled fruit.
  They may clog the spout, resulting in leakage of the contents.
• Check that the stopper is securely closed and locked.
  Contents may leak and cause soiling.

To Page Top

Precautions when Carrying the Product

Caution

• Do not set the product in a bag or the bottle boot when the exterior of the product is wet.
  Rust, disagreeable odors or dirtiness may occur.
• Do not leave the product in a bag for a long time.
  The storage conditions may change and there is a risk of rust or odors.
• Do not wave the product in the air while holding the loop (handle) on the lid cap.
  The product may hit and injure someone or damage something.
• Do not vibrate or create any impact with the product while holding the loop (handle) on the lid.
  There is a risk of loosening the stopper and dropping the body.
• Do not use the bottle by hanging it with any metal fittings or strings attached to the loop (handle) on the lid.
  Doing so may cause the main unit to fall off due to the loosen stopper.
• Do not carry together with a PC, digital camera, or other electronic device.
  If the contents leak, the electronic device may be damaged or malfunction.
• Before using the can holder, check its intensity.
  If the holder is not strong enough, it may come off and get damaged. This may result in soiling of clothes or of the interior of the vehicle.
• When using a commercially available can holder, use the stationary type.
  If the suspension holder that is attached to the window or air conditioning outlet is used, it may come off. This may result in soiling of clothes or of the interior of the vehicle.
• Keep the product in an upright position at all times in your bag to avoid leakage.
  Contents may leak if the product is laid horizontally.

To Page Top

Precautions when Using the Bottle Boot

Caution

• Do not rub the bottle boot against other objects with excessive force.
  There is a risk of color transferring to the bottle boot.
• Do not leave coffee or similar beverages on the bottle boot for a long time.
  There is a risk of color transferring to the bottle boot.
• Do not place the bottle boot on hot objects.
  There is a risk of fire or discoloring or deformation of the bottle boot.
• Do not strike the bottle boot with pointed objects.
  There is a risk that the bottle boot may be damaged with holes or tears.
• Do not pull with excessive force when removing the bottle boot.
  There is a risk of tearing or deformation of the bottle boot.
• Do not use chlorine bleach.
  There is a risk of tearing or discoloration.
• Do not use paint thinner, benzine, metal scrubbing brushes, polishing powder, cleansers, or similar substances.
  There is a risk of tearing or discoloration.
• Do not use a dishwasher or dish dryer, or wash with boiling water.
  There is a risk of discoloring or deformation of the product.

To Page Top

Precautions when Drinking

Caution

• Consume beverages as soon as possible.
  If they are left in the bottle for a long time, it can create gases that raise the air pressure inside the product due to spoilage, causing the stopper to become stuck or the contents to spurt out.
  Furthermore, there is the danger that the stopper may become damaged and cause fragmented parts to be scattered.
• Be sure to wipe spilled beverage on spout.
  The contents may leak when the lid is closed.

To Page Top

Precautions when Cleaning

Caution

• Be sure to clean the product immediately after use, especially after consuming sports drinks.
  Rinse the inside of the product well, even if you are going out, for example, and don't have time to wash it thoroughly.
  Mold, rust, or holes may appear.
• Do not use chlorine-based bleaches.
  Causes of rust, paint/printing/plating peeling*, and holes.
  *Limited to products with processing such as painting, printing and plating.
• Do not use paint thinner, benzine, metal scrubbing brushes, polishing powder, cleansers, or similar substances.
  Doing so may cause rust, scratches, and loss of cold retention ability.

To Page Top