instruction manual
INDEXProduct / Specifications
Before the first use
You may notice a particular odor coming from the material of the product. In this case, clean the product with the following steps.
- Check that all the gaskets are attached.
- Pour hot water into the body and securely close the stopper.
-
Hold the body and gently shake it several times to rinse the inside thoroughly.
Caution
- Do not shake it excessively. Doing so may cause hot water to spray out, resulting in scalds.
- Discard the hot water and clean each part.
Click here to see cleaning instructions.
How to use
-
Turn the stopper to remove it.
- Check that the lid gasket and stopper gasket are attached to the stopper.
(A) Stopper -
To improve the thermal retention performance, pour a small amount of hot/cold water into the body beforehand and let it sit for 1 or 2 minutes.
Discard the hot/cold water after preheating/precooling.
-
Pour your hot/cold beverage into the body.
- To avoid adding too much beverage, add it up to the position shown in the figure (slightly less than full).
- Do not put large cubes of ice. Use small cubes or crushed ice.
- Putting in ice causes the pressure inside the body to decrease, which can cause the gasket to come off when opening the stopper. If this occurs, reattach the gasket in its original position.
- Be sure to wipe off any spillage on the outside of the body.
- Due to the structure of the product, condensation may occur if cold beverages are put in it, generating water droplets on the stopper.
-
Place the product in an upright position and turn the stopper to close it.
- Turn the stopper as far as it will go to securely close it, and check that the stopper is securely closed.
- Set the safety lock to “Lock”. Close it securely so that the safety lock is locked in place with a “click”.
(A) Stopper
(F) Button -
Set the safety lock to “Release”, press the button, open the lid, and drink.
- Do not tilt the body immediately after pouring in a hot beverage and closing the stopper. Otherwise, the contents may leak.
(C) Stopper
(F) Button -
After drinking, return the product to an upright position and securely close the lid, and lift the button to “lock” the safety lock.
- Close it securely so that the safety lock is locked in place with a “click”.
(C) Lid
(F) Button
Caution
- When carrying the product, do not expose the product to excessive impacts. Even if the safety lock is set to “Lock”, the lid may open with an excessive impact.
- When carrying by the lid handle, be careful not to turn the product in a direction that may cause the stopper to loosen or to subject the product to strong vibration or impact. Make sure that the stopper does not become loose. The body may fall off if the stopper is loosened.
- Do not use the bottle by hanging it with any metal fittings or strings attached to the handle on the lid. There is a risk of loosening the stopper and dropping the body.
- Do not keep the body sideways. It may cause the contents to leak.
- When putting the product into a bag, place it standing up to prevent any possible leakage. Otherwise, the contents may leak.
