Introduction

• All safety instructions described below are intended to protect the user and other individuals from physical harm and property damage.
• Safety instructions are classified and described as shown below according to the level of harm or damage resulting from improper use.

Description of Symbols

To Page Top

Precautions for use

Warning

• Keep out of reach of children. Do not let children play with the product.
  There is a risk of burns or injuries.

  

Caution

• Do not disassemble or attempt to repair the product by yourself.
  There is a risk of failure or accident.
  Do not forcibly pull the gasket.
  The gasket cannot be removed. The damaged gasket may result in leakage of contents.
  Do not place the product on its side.
  The contents may spill out.
  Do not use the product for any purpose other than keeping beverages warm or cold for drinking.
  There is a risk of accidentally drinking the contents or damaging the body.

• Do not use the product if you can hear the sound of water from inside the vacuum double-layer structure (vacuum layer) of the body.
  If water in the vacuum layer seeps out, it may cause health problems if ingested. It will also reduce the thermal insulation performance and there is a risk of burns if a hot beverage is poured into the product.

  

  
• Install only the parts intended for use with the product.
  If any other parts are installed, there is a risk that the contents may leak, causing burns or stains.
• Do not use the product if its ability to retain heat declines.
  Hot beverages can make the product very hot, potentially causing burns.
• Do not place the product near stoves, open flames, or other sources of extreme heat.
  There is a risk of burns or deformation or discoloring of the product.
• Do not heat the product in a microwave oven.
  There is a risk of injury or failure due to sparks.
• Do not put the product in a freezer.
  Contents may leak or the product may be damaged.
• Do not knock over, drop or expose the product to excessive shocks.
  There is a risk of damage to the product, a reduction of its heat- or cold-retention ability, rusting, paint / printing /plating peeling*, or leakage of contents.
  * Limited to products with processing such as painting, printing, and plating.
• Do not remove the caution sticker on the body.
  If it is removed, there is a risk of diminished heat (cold) retention performance.
• Do not scratch or rub the surface of the body, resin parts, or seals with nails or hard objects.
  Causes of damage and peeling.
• Do not use the product in a moving vehicle.
  This may result in burns or soiling of clothes or of the interior of the vehicle. (Using the product while you are driving is very dangerous, as you may be distracted.)

To Page Top

Precautions when adding beverages

Caution

• Do not touch the brim of the product with a kettle spout.
  The product may fall over, causing burns or injuries to the skin, or a scratch or deformation to the product.

  

• Be sure to fill the product with drink below the maximum level shown in the diagram.
  If the contents exceed the specified line, they may leak or overflow, potentially causing burns.

  

• Do not put dry ice or carbonated beverages in the product.
  The air pressure inside the body may increase, causing the stopper part to become stuck or prone to shattering, or the parts to be damaged.
• Do not store milk, dairy products, or certain fruit juices in the product.
  The contents may decay or spoil. Long-time spoilage can create gases that raise the air pressure inside the body due to decay or spoil, causing the stopper part to become stuck or prone to shattering, or the parts to be damaged, and result in scattering of fragments.
• Do not store soups or beverages containing salt in the product.
  The product may become decayed, spoiled, or rusted.
• Do not store tea leaves or peeled fruit.
  They may clog the spout, resulting in leakage of the contents.
• Be sure to set the stopper part in proper position.
  Contents may leak and cause soiling or skin burns.

To Page Top

Precautions when carrying the product

Caution

• Do not place the product in a bag if its exterior is wet.
  There is a risk of rust, odor, or soiling.
• Do not leave the product in a bag for a long time.
  The storage conditions may change and there is a risk of rust or odors.
• Do not carry together with a PC, digital camera, or other electronic device.
  If the contents leak, the electronic device may be damaged or malfunction.
• Before using the can holder, check its intensity.
  If the holder is not strong enough, it may come off and get damaged. This may result in burns or soiling of clothes or of the interior of the vehicle.
• When using a commercially available can holder, use the stationary type.
  If the suspension holder that is attached to the window or air conditioning outlet is used, it may come off. This may result in burns or soiling of clothes or of the interior of the vehicle.
• Keep the product in an upright position at all times in your bag to avoid leakage.
  Contents may leak if the product is laid horizontally.

To Page Top

Precautions when drinking

Caution

• Do not open the stopper part when the body is tilted or placed near the face.
  Pouring hot water into the body increases the internal air pressure. This may cause the contents to burst out and scatter, potentially causing burns.
• Drink slowly and do not tilt the product abruptly when the product contains a hot beverage.
  Do not tilt the product abruptly. This may cause the contents to burst out, potentially causing burns.
• Consume beverages as soon as possible.
  If they are left in the bottle for a long time, it can create gases that raise the air pressure inside the product due to spoilage, causing the stopper part to become stuck or the contents to spurt out. Furthermore, there is the danger that the stopper part may become damaged and cause fragmented parts to be scattered.

To Page Top

Precautions when cleaning

Caution

• Do not use chlorine-based bleaches.
  Causes of rust, paint/printing/plating peeling*, and holes.
  * Limited to products with processing such as painting, printing and plating.
• Do not use paint thinner, benzine, metal scrubbing brushes, polishing powder, cleansers, or similar substances.
  Doing so may cause rust, scratches, and loss of heat (cold) retention ability.
• Be sure to clean the product immediately after use, especially after consuming sports drinks.
  Rinse the inside of the body well, even if you are going out, for example, and don’t have time to wash it thoroughly.
  Mold, rust, or holes may appear.
• When using a dishwasher, check the instruction manual for the dishwasher and detergent before using.
  There is a risk of peeling paint and/or discoloring of the product.

To Page Top