Before the first use

You may notice a particular odor coming from the material of the product. In this case, clean the product by following the steps below.

To Page Top

How to use

1. Turn the stopper part to remove it.

   

2. To improve the thermal retention performance, pour a small amount of hot/cold water into the body beforehand and let it sit for 1 or 2 minutes.

   Discard the hot/cold water after preheating/precooling.

3. Pour your hot/cold beverage into the body.

   • To avoid adding too much beverage, add it up to the position shown in the figure (slightly less than full).
   • Do not put large cubes of ice. Use small cubes or crushed ice.

   • Due to the structure of the product, when pouring a cold beverage into the body, condensation may occur and water droplets may form on the stopper part.

   

   (C) Brim
   (D) Body

4. Place the body in an upright position and turn the stopper part to close it.

   • Turn the stopper part as far as it will go to securely close it.
   • Check that the stopper part is securely closed.

   

5. To drink, hold the body and turn the stopper part.

   Caution

   • Do not tilt the body immediately after pouring in a hot beverage and closing the stopper part. Otherwise, the contents may leak.

   

6. After drinking, return the product to an upright position and securely close the stopper part.

   Turn the stopper part as far as it will go to securely close it.

   

Caution

• When putting the product into a bag, place it standing up to prevent any possible leakage. Otherwise, the contents may leak.

To Page Top